Table of Contents
Advertisement
CHAPTER
CLEANING
50
Clean the collet with the cleaning brush.
Grease the collet chuck with Milling Spindle Grease on the contact
surfaces.
ATTENTION: Use the product in small quantities. Apply on the
contact surfaces only a very thin layer of product.
Insert the collet back into the spindle and close it with both spanner
wrenches. Continue with screwing the splash guard back onto the
spindle and then turn on the air pressure.
ZIRKONZAHN – OPERATION AND MAINTENANCE M2 MILLING UNIT COMFORT LINE – VERSION: 19/05/2021
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the M2 MILLING UNIT COMFORT LINE and is the answer not in the manual?