Icom IC-91A Instruction Manual page 53

D D One-touch reply using the call record
The stored call signs in the call record can be set for opera-
tion to reply to the call.
qAfter receiving a call, push and hold [CALL/RX➝CS] for
1 sec.
Or, while pushing and holding [CALL/RX➝CS], rotate
[DIAL] to select the desired call sign record
-DUP -DUP
DV DV
439 706
B
AAAAAA
The received call sign is displayed while pushing and
holding [CALL/RX➝CS] when [DIAL] is rotated while
[CALL/RX➝CS] is pushed.
• Set your own call sign (MY) in advance. (p. 00)
• The call sign stored in "CALLER" is set to "UR," "RXRPT1" is set
to "R2" and "RXRPT2" is set to "R1."
• Error beeps sound when a call sign is received incorrectly, and
no call sign is set in this case.
wPush [PTT] to transmit; release to receive.
DV MODE OPERATION (Optional UT-121 is required for IC-91A)
25
PSKIP PSKIP
Important!
The set call signs with the "One-touch reply using the call
record" operation as at below left are for temporary opera-
tion only. Therefore, the set call signs will be erased when
another call sign is set.
• Never saved into a call sign memory.
If you want to save the set call signs, see "Copying the set
call sign contents for temporary operation"
✔ For your information
When the call that is specifying your own call sign is received,
the station and the using repeater call signs being used can
be set for operation automatically.
• When "Auto Received Call sign Set"
stored station call sign in "CALLER" is set to "UR" automat-
ically.
• When "Auto Received Repeater Call sign Set"
to ON, the stored station call sign in "RXRPT1" is set to "R2"
and "RXRPT2" is set to "R1" automatically.
7
1
2
3
4
5
6
for details.
(p. 00) 7
8
9
10
11
is set to ON, the
(p. 00)
12
13
14
is set
(p. 00)
15
16
17
18
19
47