Xtool IP608 User Manual page 29

⚫
The catalytic oxidizer is removed or replaced.
⚫
The DPF regeneration MIL is on and maintenance is performed.
⚫
The DPF regeneration control module is replaced.
The operation guidelines of the DPF function are shown as below:
1. Enter the DPF menu and choose relevant models according to the vehicle being tested.
2. Enter the DPF regeneration menu.
3. Read carefully and complete the requisites listed before performing the DPF regeneration function. Press OK after
completing the instructions shown.
4. Read the fuel tank level and make sure that it fulfills the requirement displayed.
5. Read the carbon deposit load.
Choose the "drive to warm up" option and follow the instructions listed below. Press OK after completing the instructions
6.
shown.
7. Read the instructions carefully and follow the instructions shown on the screen. Press OK after completing the
instructions shown.
27