Table of Contents
Advertisement
9.5.2
Installation
Laser servicing software version 3.22 or higher is required.
Use a PC with minimum requirements of 100MHZ and a USB 2 port. The software runs on one of the following operating
TM
systems: Windows XP
, Vista
The software contains the following files (version 3.22):
Installation procedure:
1.
Disconnect the laser module if already connected.
2.
Windows XP only: install dotNet Framework 4.
3.
Create a folder on the hard disc of your PC.
4.
Copy all files from the zip file into this folder. All files must be in the same folder.
5.
Start the servicing software by double clicking SERVICE_Vx.xx.EXE
The servicing software automatically checks the software version compatibility between servicing software and software on
the laser module during the communication initiation process. If incompatibility is detected, the servicing software cannot be
activated.
On some computers, there will be no connection to the laser module due to insufficient power of the USB inter-
face. In such a case, use a self-powered USB hub.
2021-03-23 / Rev. 10
TM
TM
, Windows 7
, Windows 8
VV016042
TM
TM,
, Windows 8.1
Windows 10
TM
.
31
Advertisement
Table of Contents
