Brocade Communications Systems Brocade ICX 6450-C Hardware Installation Manual page 35

1
2
NOTE
Do not install the rubber feet or remove the rubber feet if they are already installed.
Mounting the device on a metal surface or metal wall
NOTE
When mounting the device on a vertical metal surface, Brocade recommends that you mount the
device with the port side down.
Complete the following steps to securely mount an ICX 6450-C device on a metal surface or metal
wall:
1. Ensure that the magnet sheet is attached to the bottom panel of the device. See
2. Place the magnet sheet (with the logo side now attached to the bottom panel of the device)
FIGURE 17
Brocade ICX 6450-C Compact Switch Hardware Installation Guide
53-1002817-02
Magnet
Mylar sheet covering the bottom panel
Figure 16.
against the metal surface or metal wall. See
Mounting an ICX 6450-C device to a metal surface using the magnet mount
Installing the device
Figure 17 and Figure 18.
2
"" and
25