Brocade Communications Systems Brocade ICX 6450-C Hardware Installation Manual page 28

2
Installing the device
1. Use tape to place the Wall Mount Holes Location template against the wall, in the same
2. Using the Wall Mount Holes Location template as a guide, drill two holes on the wall where you
3. Hammer the wall mount anchors into the two holes. See
4. Use the #2 Phillips screwdriver to secure the two wall mount screws into the wall mount
18
position that you plan to place the device against the wall. The Wall Mount Holes Location
template serves as a guide to drilling the screws and mount anchors into the correct location
on the wall in order to place the device in the desired location.
want to mount the device. See
anchors. Leave a gap of 4.0 to 4.5 mm between the screw head and the wall. See
Figure 11.
Brocade ICX 6450-C Compact Switch Hardware Installation Guide
Figure 11.
53-1002817-02
Figure 11.