Brocade Communications Systems Brocade ICX 6450-C Hardware Installation Manual page 34

2
Installing the device
Before mounting the device to a metal surface using the magnet sheet, ensure that the following
requirements are met:
•
•
•
Note the following important installation considerations before installing the device on a metal
surface using the magnet mount:
•
•
When adequate ventilation is provided and the magnet is attached to the device, you can securely
mount the device in the following locations:
•
•
Attaching the magnet sheet to the device
Before mounting the device to a metal surface, place the logo side of the magnet sheet (displaying
the Brocade logo) squarely against the bottom panel of the device to attach the device to the
magnet sheet. See
CAUTION
The magnet sheet can only be placed against the bottom panel of the device. Do not attempt to
attach the magnet sheet to any other panels on the device.
FIGURE 16
24
Adequate ventilation is provided for the system. Allow 3 cm. of clearance above the device and
8 cm. of clearance on each side.
The magnet sheet is attached to the bottom panel of the device. See
sheet to the device".
Ensure that the device is not installed above a height of 1.1 meters. from the floor.
The strength of the magnet will vary depending on the surface it is used on.
The magnet's force might weaken over time. Please check the strength of the magnet
regularly, for about one year. Please move the device up and down and confirm strength.
A metal wall or metal surface. See
Underneath a metal desktop. See
Figure 16.
Attaching the logo side of the magnet sheet to the bottom panel of the ICX 6450-C device
"Mounting the device on a metal surface or metal
"Mounting the device under a metal
Brocade ICX 6450-C Compact Switch Hardware Installation Guide
"Attaching the magnet
wall".
desk".
53-1002817-02