Grandstream Networks GRP261X Administration Manual page 75

Display Contact on
MPK LCD
Wallpaper
Wallpaper Source for
MPK LCD
Upload Wallpaper for
MPK LCD
Settings  Preferences  LED Control
BLF LED Pattern
Disable VM/MSG
power light flash
Line LED Color
Scheme
BLF LED Pattern
Explanation Form
Settings  Ringtone
Call Progresses
Tones:
 System Ring Tone
 Dial Tone
 Second Dial Tone
 Message Waiting
 Ring Back Tone
 Call-Waiting Tone
 Busy Tone
 Reorder Tone
Call Waiting Tone Gain
Speaker Ring Volume

Sequential mode: MPKs will be displayed from left side to right side.

Alternating Mode: MPKs with even ID will be displayed on left side
while MPKs with odd ID will be displayed on right.
The default setting is "Sequential".
Select whether or not to display contact on MPK LCD.
The default setting is "No".
Specifies the location where wallpapers for MPK LCD are stored. Default or
Uploaded. The default setting is "Default".
Upload an image for the MPK LCD wallpaper.
Note: Must be in PNG format. 500 KB or smaller.
Configures the color and pattern of the LED based on status updates. The
default setting is "Default".
The BLF LED Patterns are listed in [BLF LED PATTERNS].
The VM/MSG light cannot flash even though there's an unread voice mail or
message when set to "Yes". Default settings is "No".
Configures the line key led color scheme.

Default : off(idle)/green(in use)

Light up: green(idle)/red(in use)
Users could view the color and pattern of the LED status based on the BLF
status update.
Configures ring or tone frequencies based on parameters from local telecom.
The default value is North American standard. Frequencies should be
configured with known values to avoid uncomfortable high pitch sounds.
Syntax: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]];
(Frequencies are in Hz and cadence on and off are in 10ms)
ON is the period of ringing ("On time" in 'ms') while OFF is the period of
silence.
In order to set a continuous ring, OFF should be zero. Otherwise it will ring
ON ms and a pause of OFF ms and then repeat the pattern. Up to three
cadences are supported.
Configures the call waiting tone gain to adjust call waiting tone volume (Low,
Medium or High). The default setting is "Low".
Configures speaker ring volume. The valid range is 0 to 7.
The default setting is 5.
GRP261x/GRP2624/GRP2634 Administration Guide
Version 1.0.5.48
P a g e | 75