Grandstream Networks GRP261X Administration Manual page 54

G723 Rate
G.726-32 Packing
Mode
iLBC Frame Size
iLBC Payload Type
OPUS Payload Type
DTMF Payload Type
Send DTMF
DTMF Delay
Account x  Call Settings
Early Dial
Dial Plan Prefix
Dial Plan
This option determines the encoding rate for G723 codec. Users can choose
from 6.3kbps encoding rate and 5.3kbps encoding rate.
The default setting is "5.3kbps encoding rate".
Selects "ITU" or "IETF" for G726-32 packing mode.
The default setting is "ITU".
This option determines the iLBC packet frame size. Users can choose from
20ms and 30ms. The default setting is "30ms".
This option is used to specify iLBC payload type. Valid range is 96 to 127.
The default setting is "97".
Specifies OPUS payload type. Valid range is 96 to 127. Cannot be the same
as iLBC or DTMF Payload Type. Default value is 123.
Configures the payload type for DTMF using RFC2833. Cannot be the same
as iLBC or OPUS payload type.
This parameter specifies the mechanism to transmit DTMF digits. There are
3 supported modes:

In audio: DTMF is combined in the audio signal (not very reliable
with low-bit-rate codecs);

RFC2833 sends DTMF with RTP packet. Users can check the RTP
packet to see the DTMFs sent as well as the number pressed.

SIP INFO uses SIP INFO to carry DTMF.
Default setting is "RFC2833".
Configures the delay between sending DTMF during MPK/VPK use (in
milliseconds). Default is "250" ms.
Selects whether to enable early dial. If it's set to "Yes", the SIP proxy must
support 484 responses. Early Dial means that the phone sends for each
pressed digit a SIP INVITE message to SIP server. SIP server considers its
extensions and, if no match happened yet, it sends back a "484 Address
Incomplete" message. Otherwise, it executes the action.
The default setting is "No".
Configures the prefix to be added to each dialed number.
A dial plan establishes the expected number and pattern of digits for a
telephone number. This parameter configures the allowed dial plan for the
phone. Default setting is "{ x+ | \+x+ | *x+ | *xx*x+ }". Dial Plan Rules:
1. Accepted Digits: 1,2,3,4,5,6,7,8,9,0 , *, #, A,a,B,b,C,c,D,d;
2. Grammar:
x – any digit from 0-9
X – digits from 0-9, and letters from a-z, A-Z.
GRP261x/GRP2624/GRP2634 Administration Guide
Version 1.0.5.48
P a g e | 54