Table of Contents
Advertisement
Enable IM Popup
Instant Message
Popup Timeout
Play Tone On
Receiving IM
Allow Incoming Call
Before Ringing
User-Agent Prefix
Auto Provision List
Starting Point
Hide BLF Remote
Status
Show SIP Error
Response
Enable Missed Call
Notification
Enable Call
Completion Service
Enable Incoming Call
Popup
Enable Enhanced
Acoustic Echo
Canceller
Auto Answer Delay
If set to "No", phone will not show a pop up when receiving an IM. The default
setting is "Yes".
Configures the number of seconds that the message will remain on screen.
The valid range is 10 – 900. The default setting is "10".
If enabled, phone will play a short tone when receiving an IM during idle
state. Default setting is "Disabled".
This allows incoming calls after dialed but before ringing. This can be used
under custom user configuration based on need. Default setting is "No".
Configures the prefix in the User-Agent header.
Users could select "VPK" or "MPK" which will be used first when the phone
is being automatically provisioned with Eventlist BLF. The default setting is
"VPK". This feature is supported only on GRP2614.
Allows users to hide the Caller ID from showing at the BLF VPK and MPK.
No: The VPK will flash between the Caller ID and the BLF account.
Yes: The VPK will stay under the monitored account and only notify that
there is an incoming call.
The default setting is "No".
Shows SIP error response information on LCD screen. The default setting is
"Yes".
Allows users to show/hide the notification popup for missed calls.
The default setting is "Yes".
Note: Currently the manually rejected calls are counted as missed calls.
When the automatic redial and call completion service are enabled, and the
user makes a call to callee, when the callee is busy at the moment, phone
will monitor callee's status. Once the callee is available, phone will ask if user
wants to redial again. The default setting is "No".
If set to "Yes", phone will pop up an incoming call window to notify the call.
If set to "No", there will be no notification pop up on LCD when there is an
incoming call. This way users will not get disrupted by unexpected popup
call but still get notified by the flashing line LED.
The default setting is "Yes".
Enables/Disables Enhanced Acoustic Echo Canceller (EAC) providing
acoustic echo reduction which is required for full-duplex handsfree speaker
phone functions on the phone. The default setting is "Yes".
Configure the delay for automatically answering the incoming call. Valid
range is 0 to 10 (second). The default value is 0 (which means auto answer
is disabled).
GRP261x/GRP2624/GRP2634 Administration Guide
Version 1.0.5.48
P a g e
|
68
Advertisement
Table of Contents
