Table of Contents
Advertisement
Mute Key Functions
While Idle
DND Override
Disable Transfer
In-call Dial Number on
Pressing Transfer Key
Attended Transfer
Mode
Transfer Mode via VPK
Hold Call in Transfer
Show On Hold
Duration
Do Not Escape #
as %23 in SIP URI
Click-To-Dial Feature
The default setting is "Yes".
Specifies the function of mute key in idle. Default setting is "DND".
When select "Idle Mute" and press Mute key while idle, the future incoming
call will be answered with mute. When select "Disabled", Mute key will not
take effect while idle.
The default setting is "DND".
Allows the phone to accept certain incoming calls while set to DND mode.
Off: all incoming calls will not be accepted.
Allow all: all incoming calls will be allowed.
Allow Only Contacts: only incoming calls from numbers in the local
phonebook will be accepted.
Allow Only Favorites: only incoming calls from favorite numbers in the
local phonebook will be accepted.
The default setting is "Off".
Enables/disables transfer feature. If disabled, call transfer will not be
possible. Default setting is "No".
Configures the number to be dialed as DTMF using TRANSFER button.
If set to "Static", attended transfers can only be performed with pre-
established calls. If set to "Dynamic", attended transfers can be performed
with pre-established calls OR be initiated during the transfer process. This
option does not affect the user's ability to perform blind transfers.
The default setting is "Dynamic".
For more details about "Static" / "Dynamic" transfer, refer to the user guide.
Perform "Blind Transfer", "Attended Transfer", or a "New Call" with the
specified number in the Value field when a user presses "Transfer" virtual
multiple-purpose key. Default is "Blind Transfer".
When set to "No", phone will neither hold the current call in transfer window
nor hold the call with the transfer target before referring the call in the
attended transfer. The default setting is "Yes".
Show the duration of holding a call on the LCD.
The default setting is "Yes".
Specifies whether to replace # by %23 or not for some special situations.
The default setting is "No".
Enables Click-To-Dial feature. If this feature is enabled, user could click the
GRP261x/GRP2624/GRP2634 Administration Guide
Version 1.0.5.48
P a g e
|
66
Advertisement
Table of Contents
