Grandstream Networks GRP261X Administration Manual page 48

Add Auth Header on
Initial REGISTER
Allow SIP Reset
Ignore Alert-Info
header
Account x  SIP Settings  Custom SIP Headers
Use Privacy Header
Use P-Preferred-
Identity Header
Use X-Grandstream-
PBX Header
Use P-Access-
Network-Info Header
Use P-Emergency-Info
Header
To define whether authorization Header will be added on initial REGISTER
from the first REGISTER. The default setting is "No".
This is used to perform a factory reset through SIP NOTIFY. When the phone
receives the NOTIFY with Event: reset, the phone should perform a factory
reset after the authentication. The default setting is "No".
This option is used to configure default ringtone. If set to "Yes", configured
default ringtone will be played. The default setting is "No".
Controls whether the Privacy header will present in the SIP INVITE message
or not, whether the header contains the caller info.

Default: The Privacy Header will show in INVITE only when "Huawei
IMS" special feature is on.

Yes: The Privacy Header will always show in INVITE.

No: The Privacy Header will not show in INVITE.
The default setting is "default".
Controls whether the P-Preferred-Identity Header will present in the SIP
INVITE message.

Default: The P-Preferred-Identity Header will show in INVITE unless
"Huawei IMS" special feature is on.

Yes: The P-Preferred-Identity Header will always show in INVITE.

No: The P-Preferred-Identity Header will not show in INVITE.
The default setting is "default".
Enables / disables the use of X-Grandstream-PBX header in SIP request.
When disabled, the SIP message sent from the phone will not include the
selected header. Default setting is "Yes".
Enables / disables the use of P-Access-Network-Info header in SIP request.
When disabled, the SIP message sent from the phone will not include the
selected header. Default setting is "Yes".
Enables / disables the use of P-Emergency-Info header in SIP request.
When disabled, the SIP message sent from the phone will not include the
selected header. Default setting is "Yes".
GRP261x/GRP2624/GRP2634 Administration Guide
Version 1.0.5.48
P a g e | 48