Table of Contents
Advertisement
5.3 Mounting the sensor
5.3.1 Overview of sensors
Designation
Inductive proximity switch IN 80
Magnetic switch MMS 22
Programmable magnetic switch MMS 22-PI2
Programmable magnetic switch MMS-P 22
Magnetic switch MMS 22-IOL
Programmable magnetic switch MMS 22-PI1
Analog position sensor APS-Z80
Reed switch RMS 80
Flexible position sensor FPS-F5 with FPS-S M8
Analog position sensor APS-M1
Radio system RSS R1/T2 with Reed switch RMS 80
5.3.2 Setting dimensions for magnetic switches
17.00 | JGZ | Assembly and Operating Manual | en | 389161
NOTE
Observe the assembly and operating manual of the sensor for
mounting and connecting.
The product is prepared for the use of sensors.
For the exact type designations of suitable sensors, please see
l
catalog datasheet and
For technical data for the suitable sensors, see assembly and
l
operating manual and catalog datasheet.
– The assembly and operating manual and catalog
datasheet are included in the scope of delivery for the
sensors and are available at schunk.com.
Information on handling sensors is available at schunk.com or
l
from SCHUNK contact persons.
* Setting dimension I1, from product bottom edge (1) to front sensor (2)
The setting dimension applies for the following sensors:
Programmable magnetic switch MMS 22-PI1
l
} 5.3.1
[/ 23].
JGZ
40
50
64
80
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
Assembly
100
125
160
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
23
Advertisement
Table of Contents
