Mounting The Sensor; Mounting The Programmable Magnetic Switch (Mms-P) - SCHUNK TCU-Z Assembly And Operating Manual

Tolerance compensation unit

Hide thumbs Also See for TCU-Z:

Table of Contents

4.4 Mounting the sensor

03.00 | TCU-Z | Assembly and operating manual | en | 389464

NOTE

Observe the assembly and operating manual of the sensor for

mounting and connecting.

The product is equipped for the use of sensors.

For the exact type designations of suitable sensors, please see

the catalog data sheet.

For technical data for the suitable sensors, see Assembly and

Operating Manual and catalog data sheet.

– The Assembly and Operating Manual and catalog data

sheet are included in the scope of delivery for the sensors

and are available at schunk.com.

Information on handling sensors is available at schunk.com or

from SCHUNK contact persons.

CAUTION

Risk of damage to the sensor during assembly!

Observe the maximal tightening torque.

NOTE

If there is no T-nut available, slide the sensor according to

dimension I1 into the groove (2), see following table.

Turn the sensor (1) into the groove (2).

OR: Slide the sensor (1) into the groove (2) until the sensor (1)

stops at the T-nut (3).

Assembly

Table of Contents