Atto Fibrebridge 2300E Characteristics - ATTO Technology FibreBridge 2300E Installation And Operation Manual

3 ATTO FibreBridge 2300E characteristics

The ATTO FibreBridge 2300E is a 2-Gigabit Fibre Channel to SCSI bridge which can be embedded in a variety
of enclosures for midrange high performance, cost effective solutions in enterprise environments.
The FibreBridge 2300 includes one Fibre Channel port
and two SCSI ports. The FibreBridge 2300E conforms
to the width of the standard 3.5-inch drive form factor.
Board dimensions
➔
3.9 inches wide (9.91 cm)
➔
7.995 inches long (20.31 cm)
Cooling and airflow
Operating Temperature: 5-40
Humiditiy: 10-90% non-condensing
Power
A drive power connector allows the FibreBridge
2300E to draw power from a standard 12/5V drive.
➔
Output voltage: +12V at 0.8 amps, +5 at 3.0
amps, +3.3V at 5 amps.
➔
Power draw: 2 amps at 110V, 1.6 amps @ 90V.
Fibre Channel port
The single 2-Gigabit Fibre Channel port can connect
the FibreBridge to either a Fabric or Arbitrated Loop.
➔
2.125 gigabit/sec.
➔
Class 2, Class 3 and ANSI Fibre Channel
specifications support
➔
PLDA, Public Loop Login (NL_port) and
Fabric Direct Connect (N_port) support
➔
Full Duplex transmission support
➔
Small Formfactor Pluggable (SFP) interface
➔
Backward compatible with 1.0625 gigabit/sec.
devices
SCSI ports
The two SCSI ports on the FibreBridge 2300 connect
storage devices into the Fibre Channel Storage Area
Network (SAN). Each port is totally independent from
the other.
5
ATTO Technology FibreBridge 2300E/R/D Installation and Operation Manual
o
C
The ports are Ultra 3 LVD/SE SCSI bues with 68-pin
"P" interface: 160 MB/sec. max throughput,
downward compatible with all forms of single-ended
SCSI.
Ethernet port
The 10/100 Base T Ethernet port acessible from the
RJ45 connector supports SNMP- and Telnet-based
monitoring and management through a command line
interface, menu system or graphical interface (ATTO
BridgeTools).
Serial interface
The 6-pin and 10-pin serial connectors provide support
for remote monitoring and management through a
command line interface, menu system or graphical
interface (ATTO BridgeTools).
LED indicators
A LED header provides support for light pipes to allow
LEDs to be run to either side of the FibreBridge 2300E
board.
➔
Power: indicates if power is available from the
supply.
➔
FC Activity: LED blinks to show activity on
the Fibre Channel port (numbered 0). During
very high activity, the LEDs appear to be
steadily lit.
➔
2 gigabit operation: a lit LED indicates the
FibreBridge is using 2 gigabit.
➔
SCSI 0 Activity, SCSI 1 Activity: each SCSI
bus has its own LED to show activity on that
bus (numbered 0 and 1).
➔
Ready: should light after power has been
applied indicating the FibreBridge is ready to
operate.