Table of Contents
Advertisement
Menu
Turns the menu interface on or off. If the interface is on, other parameters such as ECHO will also be enabled.
Action: menu < [enabled | disabled] >
Reserve
Reservation of the FibreBridge is implicit: once the configuration image is changed by any user of services, the FibreBridge becomes RESERVED.
Executing a SaveConfiguration, RestoreConfiguration or FcRestart RELEASES the FibreBridge so that other services users may access it.
Limits: When FibreBridge services interface is RESERVED, set commands from other users are unavailable.
At least one interface must always have access to the FibreBridge.
Action: Reserve
Return: [enabled | disabled]
RestoreConfiguration
Restores configuration to either the default configuration or the configuration last saved into non-volatile memory. The saved option will undo any
changes made since the last save.
Actions: RestoreConfiguration [Default | Saved]
SaveConfiguration
Many commands require a SaveConfiguration command to be executed. This will be indicated by the return Ready. *. When you invoke
SaveConfiguration, the current configuration is permanently saved in the FibreBridge and the new configuration becomes the active configuration.
If a firmware restart is required to make the requested change permanent, you will see a prompt asking you to confirm the restart. You can override
this request by indicating the override value on the command line. You may make several changes through commands and SaveConfiguration before
implementing the restart, but once you have restarted the FibreBridge, all the command changes created before the restart and save will be
implemented. If you select the restart option, the FibreBridge will execute its complete start up cycle.
Limits: Restart or no Restart parameter is optional
Actions: SaveConfiguration <Restart| NoRestart>
Returns: [Configuration saved |
Restart is necessary...
Do you wish to restart (y/n)? y
Restarting...]
SerialNumber
Reports the FibreBridge serial number which is unique for each FibreBridge. The serial number tracks the board throughout its life and should not
be changed for any reason.
Limits: set form requires operator privileges
Actions: set SerialNumber
VerboseMode
Specifies the detail of feedback for the command line interface. Disabling this option removes parameter names from action commands and removes
descriptions from information commands.
Limits: enabled or disabled
Actions: set VerboseMode [enabled | disabled]
Information: get VerboseMode
Information: none
Information: none
Information: none
Information: get SerialNumber
Verbose return:
Part Identifier: PPPPPPP Sequence Number: nnnnnn
Default: enabled (returns have parameter information)
Information: get VerboseMode
18
Advertisement
Table of Contents
