Table of Contents
Advertisement
The CLI commands outlined in this chapter may be used to get information or perform functions which
are used in a variety of situations with the ATTO FibreBridge.
CLI commands are case insensitive (upper and
lower case allowed anywhere).
FirmwareRestart
Causes the FibreBridge to reboot, then re-initialize its firmware.
Actions: FirmwareRestart
MaxEnclTempAlrm
Sets/displays the maximum enclosure temperature alarm of the unit in degrees Celsius. If the temperature of the FibreBridge rises above the maxi-
mum MaxEnclTempAlrm, thermal control event handling occurs.
Limits: valid entries are between 0 and 70 degrees and
above the current minimum enclosure temperature alarm
Actions: set MaxEnclTempAlrm [0-70]
SaveConfiguration
MinEnclTempAlrm
Sets/displays the minimum enclosure temperature alarm of the unit in degrees Celsius. If the temperature of the FibreBridge falls below the mini-
mum MinEnclTempAlrm, thermal control event handling occurs.
Limits: valid entries are between 0and 70 degrees and
below the current maximum enclosure temperature alarm
Actions: set MinEnclTempAlrm [0-70]
SaveConfiguration
ScsiPortReset
Resets the specified SCSI bus.
Actions: ScsiPortReset [sb]
RestoreConfiguration
Restores configuration to either the default configuration or the configuration last saved into non-volatile memory. The saved option will undo any
changes made since the last save.
Actions: RestoreConfiguration [Default | Saved]
SpeedWrite
SpeedWrite is a method to improve the performance of FCP WRITE commands to SCSI devices attached to the FibreBridge. You can specify the
SCSI bus, target and LUN of a mapped device or specify "all" to set or get the state of all currently mapped SCSI devices.
Limits: enabled, disabled
Actions: set SpeedWrite [sb st sl |all] [enabled |disabled] Information: get SpeedWrite [sb st sl |all]
SaveConfiguration
SpeedWriteDefault
Specifies the state of SpeedWrite for any SCSI devices mapped manually or via an AutoMap operation. If enabled, any new SCSI device will use
SpeedWrite performance enhancement by default.
Limits: enabled, disabled
Actions: set SpeedWriteDefault [enabled |disabled]
SaveConfiguration
19
ATTO Technology FibreBridge 2300E/R/D Installation and Operation Manual
8.1.2 Maintenance commands
Commands generally follow a standard format:
[Get | Set] Command [Parameter 1 | Parameter 2]
followed by the return or enter key
Information: none
Default: 70
C
o
Information: get MaxEnclTempAlrm
Default: 0
C
o
Information: get MinEnclTempAlrm
Information: none
Information: none
Information: get SpeedWriteDefault
Advertisement
Table of Contents
