Table of Contents
Advertisement
FcHard
Used to enable or disable Fibre Channel hard address assignment. Under soft addressing, the FibreBridge loop address is assigned
during loop initialization. Use FcHardAddress (described below) if you enable hard addressing.
Limits: applies to all Fibre Channel ports
Actions: setFcHard [enabled | disabled]
SaveConfiguration
FcHardAddress
Sets/displays the value used as the FC-AL hard address. This hexadecimal value represents the address the FibreBridge will try to
use if hard addressing is enabled. When an optional address is not present, the current value is displayed.
Limits: Each port has individual hard address value.
Configurations containing more than 1 FibreBridge 2300
board adhere to specific rules for assigning hard IDs: 4 (fp
0), 5 (fp1), and 6 (fp 2) on the second FibreBridge 2300.
Actions: set FcHard Address [fp |[address]]
SaveConfiguration
FibreBridgeTargetLUN
Specifies the soft target LUN(s) to be used by the FibreBridge when addressed by the host as a SCSI device.
Limits: Any map coinciding with the user-specified FibreBridgeTarget LUN must first be set to offline before trying to change it. This
map will be unavailable upon power-cycling the FibreBridge.
The get form reports all FibreBridgeTargetLUNs currently NOT disabled. Specifying a port returns the status of that port.
Action: set FibreBridgeTargetLUN [fp] [fl] | [disabled] ]
SaveConfiguration
RouteChange
Maps a Fibre Channel port and LUN to a SCSI bus, target and LUN.
Limits: Attempts to map to a SCSI device currently online results in an error message
Valid entries (FibreBridge 4500 only): fp (0-2), fl (0-31), sb (0-3), st (0-15), sl (0-7)
Action: RouteChange [fp] [fl] [sb] [st] [sl]
RouteDisplay
Returns a list of currently mapped Fibre Channel-to-SCSI routes sorted by Fibre Channel address and assembled according to the
optional parameters specified. Each list is preceded by a count of the lines that immediately follow.
Valid status values
Online: able to accept SCSI commands
Unavailable: no device currently assigned to a particular route; SCSI commands will time-out
Offline: rejects any SCSI command
Going Offline: RouteOffline has been issued, but queued commands are underway; becomes Offline when all queued commands are
complete; new SCSI commands sent to a going offline device are rejected
Action: none
Default: enabled, or hard addressing
Information: get FcHard
Default: 0 < = hard id < = 0x7d
Information: get FcHardAddress [fp]
verbose return: Port n FcHardAddress = 0x01
Information: get FibreBRidgeTargetLUN <[fp]>
Returns:
[Line Count]
[fp] [fl]
Information: none
Information:
RouteDisplay Displays all current maps
RouteDisplay [ fp] Displays specified FC port maps
RouteDisplay [online|offine] Displays all maps with route status
[online|offline]
RouteDisplay [fp [fl]] Displays the current map of fp & fl
RouteDispaly [fp [online|offline]] Displays all maps for a given FC port
with route status [online|offline]
Returns:
[line count]
[fp] [fl] [sb] [st] [sl] [Online|Offline]
30
Advertisement
Table of Contents
