Ricoh CL7000 Operating Instructions Manual page 201

Note
If you prohibit remote access using TCP/IP and then log out, you cannot use remote access. If this
was a mistake, you can use the control panel to allow access by TCP/IP.
When you prevent access via TCP/IP, you are also prevented from using "ip1394", "lpr", "ftp", "rsh",
"diprint", "web", "snmp", and "ipp".
DHCP
Use the "set" command to configure the boot method:
msh> set dhcp {on|off}
("on" means active and "off" means inactive.)
Parameter
dhcp
Note
The default is "on".
When you are using DHCP, the server also needs to be configured.
DHCP takes precedence over all other settings.
Operating Instructions
Meaning
DHCP (Dynamic Host Configuration Pro-
tocol)
Administrator Reference
201