Test Print; Print Condition - Toshiba BA400 Series Key Operation Specification

8.6 TEST PRINT

Contents of TEST PRINT menu
Menu item
<3>TEST PRINT

PRINT CONDITION

SLANT LINE(1DOT)
SLANT LINE(3DOT)
CHARACTERS
BARCODE
NON-PRINTING
FACTORY TEST
AUTO PRINT(TRANS.)
AUTO PRINT(REFL.)
8.6.1 PRINT CONDITION
The menu structure of PRINT CONDITION
Menu item
<3>TEST PRINT
PRINT CONDITION
ISSUE COUNT
PRINT SPEED
SENSOR
PRINT TYPE
ISSUE TYPE
LABEL PITCH
PAPER FEED
Notes:
1. Initial value for each parameter at a power on
ISSUE COUNT:
PRINT SPEED:
SENSOR:
PRINT TYPE:
ISSUE TYPE:
LABEL PITCH:
PAPER FEED:
2. Each fine adjustment value is effective for test print. However, the X-coordinate fine adjustment is
excluded.
3. When an error occurs during a test print, an error message is displayed and printing is stopped. At this
time, the error LED turns on and the online LED turns off.
4. The error is cleared by pressing the [PAUSE] key, and the display returns to the test print menu. At this
time, the error LED turns off and the online LED turns on. Printing is not automatically resumed after the
error is cleared.
5. The label size greater than the image buffer length cannot be designated. If it is designated, the printer
prints data equivalent to the image buffer length then stops, or the printer stops because of an error.
6. When the transmissive sensor is selected, the gap between labels shall be 3 mm.
1
4 ips
TRANSMISSIVE
THERMAL TRANSFER
NO CUT
76mm
FEED
92