Icon - Toshiba BA400 Series Key Operation Specification

(Note):
1. Whether to display or hide the 1
mode.
2. Refer to Section "6.4.2 Icon" for details on icon display.
(*1) The number of labels printed is the cumulative number of labels printed after a printer is powered on.
Number of labels printed reset to zero when the printer is turned on. During an issue with the cut interval
specified, the number of labels is updated when the label is cut normally.
(*2) [The number of remaining labels to print] = [Specified number of labels to print] – [The number of normally
printed labels before error occurs or placing the printer in pause]
When the number of remaining labels to print is zero, it is not displayed. During an issue with the cut
interval specified, the number of remaining labels is updated when the label is cut normally.
(*3) The help guide is displayed only when applicable help message exists.
(*4) The message displayed here is an IP address or supplemental information such as ribbon near end.
When LAN/WLAN setting is disabled, the IP address is not displayed even if displaying IP address is
enabled in the system mode.
The ribbon near end message is displayed when a ribbon near end is detected, regardless of whether
displaying the ribbon near end message is enabled in system mode.
A ribbon near end is detected depending on the diameter of the unused ribbon. The diameter of 38mm is
equivalent to 30-meter ribbon and the diameter of 43 mm is equivalent to 70-meter ribbon, respectively.
(*5) The model name description
BA 4 1 0 T – T
(*6) While the printer is in pause state, the ribbon near end message may be displayed on this line. The
condition of the display is the same as *4.
6.4.2

Icon

Five kinds of icon are displayed in the bottom line of the online mode screen.
These icons are displayed only in the online mode screen.
Icon
Wireless LAN icon
Link icon
st , 3 rd and 4 th lines of online mode screen can be selected in the system
Head resolution G: 203dpi, T: 300dpi
Print method T: Thermal transfer/Direct thermal, D: Direct thermal
Version
Printer Model 1: Metal Model, 2: Plastic Model
4: 4" width
Print width
Series model A:Middle Range
Displayed and used when the wireless LAN module is installed.
The graph shows the radio field strength.
Graph 0: Outside the communication range
Graph 1: Radio field strength is weak.
Graph 2: Radio field strength is middle.
Graph 3: Radio field strength is strong.
Displayed and used when the wireless LAN module is installed.
Displayed while the printer is communicating by wireless LAN.
Flashes while roaming.
Explanation
10