Advertisement
Install spacer(s)(5) in gerotor(4).
Install end cap(3) on gerotor(4) aligning
holes.
Install cap screw(1) and retainer screw
assy(2) in end cap(3). Tighten screws to
15Nm(1.5kgf m) in advance.
Then tighten screws to tightening torque
in sequence shown right figure.
Tightening torque(Standard type)
Tightening torque : 28N.M(2.9kgf m)
Displacement : 369cc/rev
If retainer screw assy(2) position is
mistaken, it is possible to cause big
trouble.
Install steering wheel to spool(12) and
make sure rotation smoothly.
(2)
Repair of front side
(Number) shows parts number of
attached parts drawing and list page 5-21.
Use a thin bladed screwdriver to pry
retaining ring(21) from housing(10).
Retaining ring(21) may burst out from
housing(10). Use goggles to protect
your eyes.
4
6
1
3
5
Port face
5-27
Anti-cavi check assy
positions
2
7
Retainer screw assy
position
100D7SS17
21
100D7SS18
Advertisement
