Advertisement
(5)
Fit the square ring (large, 36), square ring
(small, 38), backup ring (large, 37) and
backup ring (small, 39) into the brake
housing and apply oil (MOBIL #424) on
them.
Assemble the bushing (35) into the piston
(36) and assemble the piston into brake
housing. At this time, align the tap hole of
the housing and bushing hole of the
piston.
Tighten the 8 bolts for the clearance
adjustment.
Tightening torque : 3.0~3.5kgf cm
Check the square ring (2 kinds) and
backup ring (2 kinds) and replace them if
needed.
Be careful not to damage the square rings
and backup rings when assembling the
piston assy into the brake housing.
(6)
Apply loctite #5127 on the assembling
surface of the housing and assemble the
O-ring (10) into the axle tube.
(36, 37)
(33)
(10)
3-143
(36)
(38, 39)
110DEDA75
(34, 35)
110DEDA76
110DEDA77
(11)
110DEDA78
Advertisement
