Advertisement
Item
Service brake pedal
check
Service and parking
brake
system
drag
checks
Engine running
Inching check
Description
Slowly depress brake pedal.
Listen for a hissing noise that
indicates oil is flowing to brake
pistons.
LISTEN/FEEL : A hissing noise
must be heard when pedal is
depressed.
Position machine on gradual
slope.
Lower fork approximately 50mm(2
in) from ground.
Release parking and service
brakes.
LOOK : Machine must move or
coast.
OFF
NOTE : If machine does not
ON
move, check brake pedals to be
sure they fully release when feet
are removed from pedals.
Place inching switch in ON
position.
Release parking brake.
Run engine at half speed in 1st
forward.
Depress inching pedal until
machine stops with left foot.
At this pedal angle, put on right
OFF
foot on the brake pedal not to
ON
release.
Release inching pedal.
LOOK : Machine must move.
4-28
Service action
OK
Check completed.
NOT OK
Inspect for debris under
brake pedal.
Inspect
clutch cut-off linkage.
OK
Check completed.
NOT OK
Adjust park brake, go to
group 3.
NOT OK
Check
floor
mat
interference to pedal or
debris build-up.
IF OK
Check for brake pressure
when brake is released.
OK
Check completed.
NOT OK
Check inching sensor
output voltage.
Advertisement
