Advertisement
(1)
Mounting of the electric control unit
All single parts are to be checked for damaged and replaced, if required.
Prior to installation check the mobile parts in the housing for functionality. Piston can be replaced
individually.
Oil the single parts prior to installation acc. to the list of lubricants.
Place the orifices(1) with the concave
side showing upwards, until contact.
Installation position, see arrows.
The figure on the left shows the following
single parts:
1 = Pressure reducing valve
(1x, piston a. compr. spring)
2 = Vibration damper
(3x, piston a. compr. spring)
3 = Follow-on slide
(3x, piston a. compr. spring)
Install the single parts acc to right figure.
Preload the compression springs of the
follow-on slides and fasten the piston
preliminarily by means of cylindrical pins
5.0mm(assembly aid), see arrows(s)
1
1
3-115
1
D507TM214
3
2
D507TM215
S
D507TM216
Advertisement
