Advertisement
3)
ASSEMBLE THE DIFFERENTIAL ASSY
(1)
Assemble the thrust washer, side gear
and spider with gears and then install
them to the differential housing.
(2)
Assemble the differential housing.
Check marks on the differential
assembly and housing. Match to marks
at the same positions.
(3)
Tighten 12 bolts to the differential housing.
Tightening torque : 10.0~10.5kgf m
Apply 80W/90 oil on the contact
surface of the bevel gear and thrust
washer and then assemble them.
(4)
Assemble the ring gear by tighten 12
bolts.
Tightening torque : 45.0~46.0kgf m
Be careful below notes when assembling
the ring gear.
110/130DF-7 Ring-
Identification groove:1ea
gear
160DF-7
Identification groove:none
(41T)
(5)
Assemble the differential assy to the
carrier. Assemble the bearing cup and
screw to the housing. Adjust the rotation
backlash by using the screw.
Install the dial gauge on the gear tooth
and measure the backlash while rotating
the bevel gear.
Rotation backlash : 0.15~0.25mm
3-138
110DEDA59
110DEDA60
110DEDA61
110DEDA62
Advertisement
