Advertisement
Preassemble the opposite side
The figure on the right shows the followi-
ng single parts:
1 = Main pressure valve
(1x, piston a. compr. spring)
2 = Vibration damper
(3x, piston a. compr. spring)
3 = Follow-on slide
(3x, piston a. compr. spring)
Install the single parts acc to right figure.
Preload the compression springs of the
follow-on slides and fasten the pistons
preliminarily by means of cylindrical
pins(S) 5.0mm(assembly aid), see
arrows(S).
Install two adjusting screws.
(S)Adjusting screws M5
Assemble flat gasket(1) and housing
cover. Then place the housing cover by
means of adjusting screws equally until
contact.
Preload the pistons with cap screws and
remove the cyl. pins(assembly aid) again.
Then fasten the housing cover by means
of cap screws(1).
Tightening torque - - - - - - - - - - - - - M
(S)Adjusting screws
(S)Torque spanner
(S)Reducer
(S)Socket spanner TX-27 5873 042 002
5870 204 036
=0.56kg m
A
5870 204 036
5870 203 031
5870 656 056
3-117
3
1
1
1
2
D507TM221
S
D507TM22
D507TM223
Advertisement
