Table of Contents
Advertisement
Note:
1. Don't input power into the "DC12/3A OUTPUT" port.
2. Don't output this DC12V/3A power to the DC12V/IN port of the IP camera tester to avoid destroy
3. The IPC tester power output is close to 3A, if the IP camera's power is over 3A, the tester will auto
enter protection mode. Disconnect all the connections of the tester and then connect the tester with
power adaptor to resume the tester.
4. Before turning on the PoE power output, please make sure the IP camera supports PoE power.
Otherwise it may damage the IP camera.
5. Make sure you plug in your IP camera to the LAN port prior to turning on PoE power
6. Make sure the tester is full charged or more than 80% charged, otherwise the tester will shows
"low power", "not able to supply power".
3.3.21 DC 24V 2A power output
The top and the bottom of the "DC24V ON/0W "is power output interface.
Application:
Power output function is mainly used in the camera field demonstration and testing, meanwhile, for
some camera installation sites, if there is no power outlet, the tester can offer temporary power for
Page.65.
Advertisement
Table of Contents
