Table of Contents
Advertisement
3.3.19 PoE power / DC12V 2A power output
When the tester is turned on, the DC12V power output functions are automatically turned on.
To use the PoE Power Output function, click on the icon
"OFF".
The IP camera needs to be connected to the LAN port before you turn PoE Power on. If the IP camera
Supports PoE, the PoE power is delivered via pins 1, 2, 3, and 6 on the LAN port. The IP tester will
display "48V ON" at the top of the screen when the POE power is still on.
Note:
1. Don't input power into the "DC12/2A OUTPUT" port.
2. Don't output this DC12V/2A power to the DC12V/IN port of the IP camera tester to avoid destroy
3. The IPC tester power output is close to 2A, if the IP camera's power is over 2V, the tester will auto
enter protection mode. Disconnect all the connections of the tester and then connect the tester with
power adaptor to resume the tester.
4. Before turning on the PoE power output, please make sure the IP camera supports PoE power.
Otherwise it may damage the IP camera.
5 Make sure you plug in your IP camera to the LAN port prior to turning on PoE power
6. Make sure the tester is full charged or more than 80% charged, otherwise the tester will shows
"low power", "not able to supply power".
and change the switch "ON" or
Page.67.
Advertisement
Table of Contents
