Table of Contents
Advertisement
342
6-3. Do-it-yourself maintenance
5
Install the lens.
Hooks
1
Fit the lens into either the right
or left hooks.
2
Push the lens into place.
After installation, confirm that the lens is
properly installed by gently pulling it.
6
Install the cover.
WARNING
■
To prevent injury
Before performing any light bulb
replacement procedure, be sure to
turn the engine switch off. Failure to
do so may result in burns from hot
components or a part of your body
may get caught on an operating com-
ponent, possibly causing serious
injury.
■
Replacing light bulbs
●
Turn off the lights. Do not attempt to
replace the bulb immediately after
turning off the lights.The bulbs
become very hot and may cause
burns.
●
Do not touch the glass portion of
the light bulb with bare hands.
When it is unavoidable to hold the
glass portion, use and hold with a
clean dry cloth to avoid getting
moisture and oils on the bulb. Also,
if the bulb is scratched or dropped,
it may blow out or crack.
●
Fully install light bulbs and any
parts used to secure them. Failure
to do so may result in heat damage,
fire, or water entering the light unit.
This may damage the lights or
cause condensation to build up on
the lens.
●
Do not attempt to repair or disas-
semble light bulbs, connectors,
electric circuits or component parts.
Doing so may result in death or
serious injury due to electric shock.
■
To prevent damage or fire
●
Make sure bulbs are fully seated
and locked.
●
Check the wattage of the bulb
before installing to prevent heat
damage.
Advertisement
Table of Contents
