Light Bulbs - Toyota KLUGER 2021 Owner's Manual

336
6-3. Do-it-yourself maintenance
■
After a fuse is replaced
●
If the lights do not turn on even after
the fuse has been replaced, a bulb
may need replacement. (P.336)
●
If the replaced fuse blows again, have
the vehicle inspected by your Toyota
dealer.
■
If there is an overload in a circuit
The fuses are designed to blow, protect-
ing the wiring harness from damage.
■
When replacing light bulbs
Toyota recommends that you use genu-
ine Toyota products designed for this
vehicle. Because certain bulbs are con-
nected to circuits designed to prevent
overload, non-genuine parts or parts not
designed for this vehicle may be unusa-
ble.
WARNING
■
To prevent system breakdowns
and vehicle fire
Observe the following precautions.
Failure to do so may cause damage
to the vehicle, and possibly a fire or
injury.
●
Never use a fuse of a higher
amperage rating than that indi-
cated, or use any other object in
place of a fuse.
●
Always use a genuine Toyota fuse
or equivalent.
Never replace a fuse with a wire,
even as a temporary fix.
●
Do not modify the fuses or fuse
boxes.
NOTICE
■
Before replacing fuses
Have the cause of electrical overload
determined and repaired by your
Toyota dealer as soon as possible.

Light bulbs

You may replace the following
bulbs by yourself. The diffi-
culty level of replacement var-
ies depending on the bulb. If
necessary bulb replacement
seems difficult to perform,
contact your Toyota dealer.
For more information about
replacing other light bulbs,
contact your Toyota dealer.
Preparing for light bulb
replacement
Check the wattage of the light bulb
to be replaced. (P.394)
Turning off the power back
door main switch (if
equipped)
P.400
Bulb locations

Front (type A)
Front turn signal lights