Table of Contents
Advertisement
106
3-2. Opening, closing and locking the doors
NOTICE
●
Take care not to damage the sen-
sors (installed on the right and left
edges of the power back door) with
a knife or other sharp object. If a
sensor is disconnected, the power
back door will not close automati-
cally.
■
Hands Free Power Back Door
precautions (if equipped)
The kick sensor is located behind
lower center part of the rear bumper.
Observe the following to ensure that
the Hands Free Power Back Door
function operates properly:
●
Keep the lower center part of the
rear bumper clean at all times.
If the lower center part of the rear
bumper is dirty or covered with snow,
the kick sensor may not operate. In
this situation, clean off the dirt or
snow, move the vehicle from the cur-
rent position and then check if the
kick sensor operates. If it does not
operate, have the vehicle inspected
by your Toyota dealer.
●
Do not apply coatings that have a
rain clearing (hydrophilic) effect, or
other coatings, to the lower center
part of the rear bumper.
●
Do not park the vehicle near objects
that may move and contact the
lower center part of the rear
bumper, such as grass or trees.
If the vehicle has been parked for a
while near objects that may move and
contact the lower center part of the
rear bumper, such as grass or trees,
the kick sensor may not operate. In
this situation, move the vehicle from
the current position and then check if
the kick sensor operates. If it does not
operate, have the vehicle inspected
by your Toyota dealer.
●
Do not subject the kick sensor or its
surrounding area to a strong
impact.
If the kick sensor or its surrounding
area has been subjected to a strong
impact, the kick sensor may not oper-
ate properly.
If the kick sensor does not operate in
the following situations, have the
vehicle inspected by your Toyota
dealer.
• The kick sensor or its surrounding
area has been subjected to a strong
impact.
• The lower center part of the rear
bumper is scratched or damaged.
●
Do not disassemble the rear
bumper.
●
Do not attach stickers to the rear
bumper.
●
Do not paint the rear bumper.
●
If a heavy object is attached to the
power back door, disable the kick
sensor.
Adjusting the open position
of the back door (vehicles
with a power back door)
The open position of the power
back door can be adjusted.
1
Stop the power back door at the
desired position. (P.99)
2
Press and hold the power back
door switch on the back door for
approximately 2 seconds.
• When setting is complete, a
buzzer will sound 4 times.
• The next time the power back
door is opened, it will stop at that
Advertisement
Table of Contents
