Table of Contents
Advertisement
WARNING
■
Cautions regarding the use of
the system
There is a limit to the degree of recog-
nition accuracy and control perfor-
mance that this system can provide,
do not overly rely on this system. The
driver is always responsible for paying
attention to the vehicle' surroundings
and driving safely.
■
To ensure the system can oper-
ate properly
Observe the following precautions.
Failing to do so may result in the vehi-
cle being unable to be driven safely
and possibly cause an accident.
●
Do not damage the sensors, and
always keep them clean.
●
Do not attach a sticker or install an
electronic component, such as a
backlit license plate (especially fluo-
rescent type), fog lights, fender pole
or wireless antenna near a radar
sensor.
●
Do not subject the surrounding area
of the sensor to a strong impact. If
subjected to an impact, have the
vehicle inspected by your Toyota
dealer. If the front or rear bumper
needs to be emoved/installed or
replaced, contact your Toyota
dealer.
●
Do not modify, disassemble or paint
the sensors.
●
Do not attach a license plate cover.
●
Keep your tires properly inflated.
■
When to disable the function
In the following situations, disable the
function as it may operate even
though there is no possibility of a colli-
sion.
●
Failing to observe the warnings
above.
4-5. Using the driving support systems
●
A non-genuine Toyota suspension
(lowered suspension, etc.) is
installed.
■
Notes when washing the vehicle
Do not apply intensive bursts of water
or steam to the sensor area.
Doing so may result in the sensor
malfunctioning.
●
When using a high pressure
washer to wash the vehicle, do not
spray the sensors directly, as doing
so may cause a sensor to malfunc-
tion.
●
When using steam to clean the
vehicle, do not direct steam too
close to the sensors as doing so
may cause a sensor to malfunction.
■
The system can be operated when
●
The engine switch is in ON.
●
Toyota parking assist-sensor function
is on.
●
The vehicle speed is less than about
10 km/h (6 mph).
●
A shift lever other than P.
■
If "Parking Assist Unavailable" is
displayed on the multi-information
display
●
Water may be continuously flowing
over the sensor surface, such as in a
heavy rain. When the system deter-
mines that it is normal, the system will
return to normal.
●
Initialization may not have been per-
formed after a battery terminal was
disconnected and reconnected. Initial-
ize the system. (P.232) If this mes-
sage continues to be displayed even
after initialization, have the vehicle
inspected by your Toyota dealer.
■
If "Parking Assist Unavailable
Clean Parking Assist Sensor" is
displayed on the multi-information
display
A sensor may be covered with ice,
231
4
Advertisement
Table of Contents
