Table of Contents
Advertisement
102
3-2. Opening, closing and locking the doors
●
When the engine switch is in ON, one
of the following conditions must be
met in addition to the above condi-
tions:
• The parking brake is engaged.
• The brake pedal is depressed.
• The shift lever is in P.
■
Operation of the power back door
●
When the power back door begins to
operate, the emergency flashers will
flash twice and a buzzer will sound.
●
A buzzer sounds to indicate that the
back door is operating.
●
When the power back door is disa-
bled, the power back door will not
operate but can be opened and
closed manually.
●
When the power back door is open-
ing/closing, if the power back door
becomes obstructed, operation will
stop.
■
Jam protection function
Sensors are installed on the right and
left sides of the power back door. When
the door is automatically closing and the
sensors are pushed due to an object
being clamped, etc., the jam protection
function operates.
From that position the door automati-
cally moves a little in the opposite direc-
tion and then the function stops.
■
Back door reserve lock function
This function reserves the locking of the
power back door when the power back
door is open. If the following operations
are performed, all of the doors except
the power back door will lock and then
the power back door will lock when it is
completely closed.
1
Close all of the doors, except the
back door.
2
Perform an automatic closing opera-
tion of the power back door and lock
the doors using the wireless remote
control (P.93) or smart entry &
start system (P.93) while the
power back door is closing.
A buzzer sounds and the emergency
flashers flash to indicate that all the
doors have been closed and locked.
●
If the electronic key is placed inside
the vehicle after starting a close oper-
ation via the door reserve lock func-
tion, the electronic key may become
locked inside the vehicle.
●
If the back door does not fully close
due to the operation of the jam protec-
tion function, etc., while the back door
is automatically closing after a door
reserve lock operation is performed,
the door reserve lock function is
canceled and all the doors will unlock.
●
Before leaving the vehicle, make sure
that all the doors are closed and
locked.
■
Kick sensor operating conditions
(vehicles with a Hands Free Power
Back Door)
●
When the kick sensor operation set-
ting is turned on (P.396) and the
engine switch is turned off.
●
When an electronic key is carried
within the operation detection area.
■
Situations in which the Hands Free
Power Back Door may not operate
properly (if equipped)
In the following situations, the Hands
Free Power Back Door may not operate
properly:
●
When a foot remains under the rear
bumper.
●
If the rear bumper is strongly hit with a
foot or is touched for a while.
If the rear bumper has been touched for
a while, wait for a short time before
attempting to operate the Hands Free
Power Back Door again.
Advertisement
Table of Contents
