Installing The Fork Protector; Bleeding The Fork Legs; Removing The Seat - Husqvarna 701 Supermoto 2023 Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.9
12.10
12.11
52

Installing the fork protector

H00401-11

Bleeding the fork legs

S04585-12

Removing the seat

V00524-10
–
Position the fork protector on the left fork leg. Mount and
1
tighten screws .
Guideline
Remaining screws,
chassis
–
Position the brake line, wiring harness, and clamp. Mount and
2
tighten screws .
–
Position the fork protector on the right fork leg. Mount and
3
tighten screws .
Guideline
Remaining screws,
chassis
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
Release bleeder screws
Any excess pressure escapes from the interior of the
fork.
–
Tighten the bleeder screws.
Info
Carry out this operation on both fork legs.
Finishing work
–
Remove the motorcycle from the lift stand. (
–
1
Pull on loop while raising the rear of the seat.
–
Pull off the seat sideways at the front ends from the side
cover.
–
Pull seat back and lift it off.
M6 10 Nm (7.4 lbf ft)
M6 10 Nm (7.4 lbf ft)
p. 49)
1
.
p. 49)