Table of Contents
Advertisement
17 TUNING THE ENGINE
17.3
17.4
102
Checking the basic position of the shift lever
Info
When driving, the shift lever must not touch the rider's boot when in the basic position.
When the shift lever keeps touching the boot, the transmission will be subject to an excessive load.
400692-10
Adjusting the basic position of the shift lever
401950-12
401951-10
Info
If the TC indicator lamp and both riding mode
lamps light up at same time, a malfunction has
been detected in the traction control. Contact
an authorized Husqvarna Motorcycles work-
shop.
–
Sit on the vehicle in the riding position and determine
A
distance
between the upper edge of your boot and the
shift lever.
Distance between shift lever
and upper edge of boot
»
If the distance does not meet specifications:
–
Adjust the basic position of the shift lever.
(
p. 102)
–
1
Remove screw
with the washers and take off shift
2
lever
.
–
A
Clean gear teeth
of the shift lever and shift shaft.
–
2
Mount shift lever
on the shift shaft in the required position
and engage the gearing.
Info
The range of adjustment is limited.
The shift lever must not come into contact with any
other vehicle components during the shift procedure.
–
Mount and tighten screw
Guideline
Screw, shift
M6
lever
10 ... 20 mm (0.39 ...
0.79 in)
1
with washers.
14 Nm (10.3 lbf ft)
Loctite
®
243™
- Quick Links:
- Combination Instrument 7
Hide quick links:
Advertisement
Table of Contents
