Husqvarna 701 Supermoto 2023 Owner's Manual page 79

–
Clean and grease the thread of the wheel spindle and nut
Long-life grease (
–
Clean and grease the wheel spindle.
Long-life grease (
–
Mount the damping rubber and rear sprocket carrier in the
rear wheel.
–
Position the rear wheel.
The brake linings are correctly positioned.
–
Push the rear wheel forward as far as possible and lay the
chain on the rear sprocket.
–
Mount wheel spindle
2
nut , but do not tighten yet.
–
Make sure that chain adjusters
adjusting screws
Guideline
In order for the rear wheel to be correctly aligned, the
markings on the left and right chain adjusters must be in
S01005-10
the same position relative to reference markings
Info
Mount left and right chain adjusters
position.
–
2
Tighten nut
Guideline
Nut, rear wheel spin-
dle
–
Position wheel speed sensor
–
Mount and tighten screw
Guideline
Screw, wheel
speed sensor
–
Position the brake line in the guide.
–
Operate the foot brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
F00598-10
Finishing work
–
Remove the rear of the motorcycle from the wheel stand.
( p. 50)
–
Check the chain tension. (
WHEELS, TIRES 14
p. 129)
p. 129)
3
and chain adjuster
4
are fitted correctly on
5
.
4
.
M25x1.5 90 Nm (66.4 lbf ft)
6
in the hole.
7
.
M6 6 Nm (4.4 lbf ft)
p. 57)
2
.
4
. Mount
B
.
in the same
®
Loctite 243™
77