idp SMART Series User Manual page 71


RFID(13.56MHz) Usage
The RFID Tag is used for the security and the recognition of the ribbon. To get the optimized printing
quality on the printed card, the genuine ribbon of IDP should be used to print cards by using SMART
printer. SMART printer can recognize the genuine ribbon by reading the encoded information on the
RFID Tag of the ribbons. To support user's various requirements for printing cards appropriately,
many kinds of ribbons should be provided and SMART printer should distinguish the type of installed
ribbon. To distinguish the installed ribbon type correctly, SMART printer reads the encoded
information on the RFID Tag of the ribbons. According to the installed ribbon type and the ribbon
supplier, the printer driver of SMART printer can select the color profile and create the printing data.
FCC Compliance Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from which the receiver is connected. •
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution
Any changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate this equipment. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
57