idp SMART Series User Manual page 43

SBS Only: Please enable it when you issue cards with software programed by SDK. This
option disables printer device driver.
Safe Head Heat: Set not to print if the print head is overheated.
Cleaning Warning: Set to show the 'Do cleaning' message periodically
Use USB Serial: When SMART-21 is connected to USB, it transmits the USB serial
number to PC. Default is the same number used by all SMART-21. Please set this option
when you use multiple SMART-21 printers connected to 1 PC via USB. It enables unique
serial numbers for each USB.
Mag. Head Position: SMART-21 can install the magnetic encoder on upper/lower side of a
card. You can set it depending on the position of encoder.
Card Out: Set the way to eject cards.
Error Card Out: Set the way to eject error cards.
Auto Front Card In: Set to input a card automatically if the front card-in sensor detects a
card. It is used for the KIOSK model.
Auto Rear Card In: Set to input a card automatically if the rear card-in sensor detects a
card. It is used for the KIOSK model.
Dump Mode: It records log data to inspect the operation of printer.
User Mag. Current: The default current value when the user selects to use the defined
value when magnetic encoding
Mag. Write Mode: You can order the way how to encode magnetic stripe.
"L:A, H:I": encodes 3 tracks at once for LoCo card and encodes at twice by dividing 1,3 and
2 track for HiCo card.
Magnetic Start Position: Set the start position of magnetic stripe when you encode.
Magnetic Write Speed: Set the speed of magnetic encoding.
Flipper Cover Open: THIS FEATURE IS NOT SUPPORTED IN SMART-21.
Card In Speed: THIS FEATURE IS NOT SUPPORTED IN SMART-21.
Card Move Speed: set the speed of moving a card
Card Eject Speed: set the speed of ejecting a card
Card In Delay: Set the delay time after the card feed.
Stability Interval: Set the interval for printer operation stability.
Hopper Align: THIS FEATURE IS NOT SUPPORTED IN SMART-21.
Hopper Align Time: THIS FEATURE IS NOT SUPPORTED IN SMART-21.
Stability Mode: Set the control method for printer operation stability. When set to "Safe", it
slows down the speed however increases stability over "default".
29