idp SMART Series User Manual page 17

(4) Install a ribbon into the ribbon
cartridge as the right picture.
(5) Insert the supply side of the
ribbon to no.1 hole and press the
opposite (no.2). Insert the take-up
side of the ribbon same method to
no.3 and no.4. After inserting,
tighten the ribbon.
(Caution! If the ribbon is not tightened, a
rolling up error might be happened.)
(6) Install the disposable cleaning roller
to the ribbon cartridge.
(The ribbon tag side of the supply core should
be mounted in the direction of the ribbon tag
marking on the cartridge.)
(7) Peel the protective wrapper from the
cleaning roller.
After removing the protective wrapper, the
cleaning roller should be kept clean from
fingerprints, dust and foreign substances to
avoid contamination because it is adhesive.
(Caution! Do not use without peeling off the
protective wrapper because the cleaning
roller cannot perform its function.)
Figure 8 Loading the ribbon 1
①
②
Figure 9 Loading the ribbon 2
Figure 10 Installing the cleaning roller
Figure 11 Peeling the protective wrapper
3
③
④