idp SMART Series User Manual page 38

④ To show firmware version, serial number of printer and serial number, resister & type of
print head.
⑤ To show print area. It shows
⑥ To set print area. Please set it properly to print on an entire card because SMART-21 is
a direct thermal card printer. When you click "⑦ Print", a card is printed as like "④
example". Please set values properly that all circles of each corner are printed and
blank spaces are 0.4mm ~ 0.5mm in the top and the bottom of a card. Please set
values by following order.
X Start Position: Please set right and left properly by adjusting X position.
Y Start Position: Please set the start position of printed example image and blank
space in the top is 0.4mm ~ 0.5mm.
Y End Position: Please set the end position of printed example image and blank
space in the bottom is 0.4mm ~ 0.5mm. It is recommended to set bigger value for
"Y scale" than default.
Y Scale: Please set to show circles in the bottom.
⑦ To set density. SMART-21 enables to set different density for each color, resin black
and overlay. So, please set each density for high quality. Please optimize the quality by
adjusting each value. To optimize, you repeatedly adjust the density and print a
Calibration card and check the print state until you get the optimum.
Total Density: To set all of the density (Color, Black and Overlay) at one time.
YMC Density: To set color density. Please maximize YMC density as you can, which
enables to express range of color and vivid images. If it is too strong, green or red
marks are appeared. If it is too weak, the print quality will be dull.
for user convenience.
exaggeratingly
24