Main Control Panel Display And Settings; Settings Using The Mode Button - Sime MURELLE REVOLUTION 30 User, Installation And Servicing Instructions

Hide thumbs Also See for MURELLE REVOLUTION 30:

User, installation and servicing instructions (100 pages)

Table of Contents

– as soon as the symbols begin to flash, release the buttons

and

and press the button

– the "Automatic self-calibrating procedure" starts

– open one or more than one hot water tap

– the values flash on the display: "100" (maximum value), fol-

lowed by an "intermediate value" and finally "00" (minimum

value)

The operator must wait for approximately 15 minutes for the

"self-calibrating procedure" to end and the message "SUMMER

mode"

to reappear on the display. Once the procedure has

terminated:

– close the taps opened previously and check that the appliance

shuts down.

if there is a fault, the message "ALL" will appear on the display,

the fault code (eg. "06" - no flame detected) and the message

CAUTION

To restore the start conditions press and hold the but-

ton

for more than 3 seconds. This operation can

be performed up to a maximum of 6 times without the

"self-calibrating procedure" being interrupted.

– press the button

"WINTER mode"

. The value of the heating water tempera-

ture detected at that moment will appear on the display

– adjust the air thermostat and check that the boiler starts and

operates correctly

– carry out the procedure "Chimney sweeper function", to

check the mains gas pressure, detect the combustion param-

eters and to measure the combustion efficiency required by

legislation in force.

, within 3 seconds

once for at least 1 second to select

6.3