Main Control Panel Display And Settings; Settings Using The Mode Button - Sime MURELLE REVOLUTION 30 User, Installation And Servicing Instructions

Wall-mounted hybrid condensing boiler

Hide thumbs Also See for MURELLE REVOLUTION 30:

User, installation and servicing instructions (68 pages)

100

page of 100

/ 100
Contents
Table of Contents
Bookmarks

Table of Contents

Enlarged version

– as soon as the symbols begin to flash, release the buttons

and

and press the button

– the "Automatic self-calibrating procedure" starts

– to dissipate the heat , tun on one or more DHW taps

– the values flash on the display: "100" (maximum value), fol-

lowed by an "intermediate value" and finally "00" (minimum

value)

It may take up 15 minutes for the "self-calibrating procedure"

to end and the message "SUMMER mode"

the display Once the procedure has terminated:

– close the taps opened previously and check that the appli-

ance shuts down.

if there is a fault, the message "ALL" will appear on the display,

the fault code (eg. "06" - no flame detected) and the message

CAUTION

To restore the start conditions press and hold the but-

ton

for more than 3 seconds. This operation can

be performed up to a maximum of 6 times without the

"self-calibrating procedure" being interrupted.

– press the button

once for at least 1 second to select

"WINTER mode"

. The value of the heating water temper-

ature detected at that moment will appear on the display

– operate the heating controls and check that the boiler starts

and operates correctly

– using the procedure shown in section "Chimney sweep func-

tion"complete inlet working gas pressure test and a flue gas

analysis.

, within 3 seconds

to reappear on

6.3