Filter Pump Test; Pre­use Cleaning - GILES GBF-80 Operation & Service Manual

GBF−80G
2.10.4.

Filter Pump Test

The following test will verify that the Filter Pump is operating correctly.
1. Place the POWER switch
& open cabinet door.
2. With the filter pan disconnected, place the palm
of the hand tightly over the opening of the filter
②
pan quick­coupling
3. Briefly place the PUMP switch
position & allow pump to briefly run, then return
to OFF. If good suction is felt with pump running,
it is operating correctly ... continue to Section
2.11.
If the pump does not run, or no or little suction is
felt, refer to the Section 7, Troubleshooting.
If the pump is blowing air out, a service
technician will be needed to reverse the pump
rotation.
2.11. Pre−Use Cleaning
● Before cooking in fryer, perform a Boil‐Out procedure to remove dirt that may have accumulated during shipping &
any residue which may remain from manufacturing processes. See Section 5.1, Boil‐Out Procedure. After
completion proceed to Section 2.12.
● Thoroughly clean the filter pan to remove dirt or debris that may have accumulated during shipping, and any residue
which may remain from manufacturing processes. See Section 5.2, Cleaning Filter Pan & Replacing Filter Media
After Boil Out.
● Before use, wash all fryer accessory items (baskets, basket lift carriers, vat screen, tools, brushes, etc.) in hot soapy
water, rinse & dry thoroughly.
14
①
in the [ON] position
.
③
in the [ON]
3
2
Installation
1