1: 6815 Connection To The Panel; 5824 Serial/Parallel Interface Module Installation - Honeywell 6820 Manual

5824 Serial/Parallel Interface Module Installation

Figure 4.30 is a drawing of the 6815 board, showing the location of terminals and DIP switches.
4.11.1 6815 Connection to the Panel
Connect the 6815 to the control panel as shown in Figure 4.31. After the 6815 is connected to the panel, it must be added to the system. This
programming steps are described in Section 8.2.2.
FACP
EXT. COMM
4.12 5824 Serial/Parallel Interface Module Installation
The 5824 serial/parallel interface module allows you to connect a printer to the panel, so you can print a real-time log of system events.
Instructions for installing the 5824 appear below. The 5824 is for ancillary use only.
5824 installation involves the following steps:
1. Ensure that all power has been removed from the FACP.
2. Connect the 5824 to the FACP as shown in Figure 4.32.
NOTE: There is a maximum of four 5824 modules allowed per panel.
3. Use the DIP switches on the 5824 board to assign an SBUS ID# to the 5824 (see Section 4.15.1).
6820/EVS Manual — P/N LS10144-001SK-E:E 4/6/2022
DIP switches for
setting IDs
to panel SBUS
–
+
A B
S B U S
Figure 4.30 6815 Board
6815
–
+
A B S C -
S B U S
S L C O U T
Figure 4.31 6815 Connection to FACP
to SLC loop
S C - S + S C - S +
S L C O U T S L C IN
–
+
S + S C - S + A
S B U S
S L C IN
Control Panel Installation
6815
B S C - S + S C - S +
S L C O U T S L C IN
supervised,
power-limited
43