Step 6. Remove The Old Left Side Outer And Inner Brackets - Keysight Technologies N5222B Installation Notes

Description of this Upgrade

Step 6. Remove the Old Left Side Outer and Inner Brackets

Step 6. Remove the Old Left Side Outer and Inner Brackets
See also your Service Guide's "Removing and Replacing the Fans" section. Set
aside all hardware for reuse.
IMPORTANT! If you have an instrument with a serial number prefix <5200
you will need to replace the right inner fan bracket (N5221-00003). Refer
to the Service Guide's "Removing and Replacing the Fans" section and to
Table on page
Remove the Old Left-side Outer Panel/Bracket (Refer to
1. Remove screws (item
2. Lift and remove the old outside left side bracket out of the analyzer. (item
Figure 7 Remove Left-side Outer Bracket and Screws (0515-0372)
22
9.
outside bracket to the chassis (item

).

) – (seven on the left side) that attach the old

).
Figure 7 on page
Installation Note N5222-90133
22.)