Keysight Technologies N5222B Installation Notes page 32

4-port pna direct digital synthesizer (dds) upgrade kit
Hide thumbs Also See for N5222B:
Table of Contents

Advertisement

Description of this Upgrade
Step 11. Reinstall Bottom Assemblies and Cables
Install the following LFE cables as shown in
top-side end of the cables are installed later.
Figure 16
Install the Bottom-side End of the *NEW* LFE Cables (N5240-60112,
N5240-60113)
C. Reinstall the A19 Test Set Motherboard
Refer to your Service Guide's "Removing and Replacing the A19 Test Set
Motherboard" section. Reuse hardware that was set aside from removal step.
D. Reinstall the A34 and A42 Port 1 Attenuators
Refer to your Service Guide's "Removing and Replacing the A34–A37 Source
Attenuators, the A38–A41 Bias Tees, and the A42–A45 Receiver Attenuators"
section. Reuse all hardware that was set from removal step.
32
Figure 16 on page
32. The
Installation Note N5222-90133

Advertisement

Table of Contents
loading

This manual is also suitable for:

N5221bN5241bN5242bN5249b

Table of Contents