TA Instruments DISCOVERY XENON FLASH Getting Started Manual page 61

8 Put the Detector back in place, lowering it back into the sample area. Note that the Detector Head is
difficult to lower when pressing down only on the Detector Head. Instead, press down the Detector Head
while simultaneously pressing down on the Detector arm, as shown below.
Figure 44 Lowering the Detector Head.
Lock the Detector Head into place. Make sure the clips do not get stuck in the clip groove as shown in the
left image below.
Figure 45 Left: Incorrect clip position. Middle: Correct clip position. Right: Clip in the locked position.
DXF Getting Started Guide Page 61