Table of Contents
Advertisement
4
Enter the test parameters and then click Start Test.
Figure 34 Test Information window.
Top section of the Test Information window:
•
Test Title: The entered information is added to the test information file for future reference.
•
Test ID: The name of the test saved in the Instrument Data folder. The Test ID number advances
automatically. Add a short description (ex. 123_Stainless_Steel) for future reference.
•
Operator: Enter the name or initials of the person running the test for future reference.
•
Use Information from Previous Test: Fills most fields with information from the previously
saved test.
•
Pins/Autosampler Control: Opens a window that allows command of the tray and pins position,
verify tray and pin position, and can be used to lower pins for cleaning and rotate the tray for sam-
ple loading.
•
Common Sample ID, Common Sample Title, Common Sample Thickness, Common Tension
%: Sets every sample position with the value entered in the Position 1 fields.
NOTE: When only one sample is used, it must be set in position 1. Samples can not be skipped–the second
sample must be tested in position 2, third sample in position 3, etc. Only the samples with information
entered in the Sample ID column will be tested. If only 4 out of 12 samples tested, the rest of the positions'
Sample ID text (Sample ID 5 to 12) must be cleared.
•
Use Expansion: Allows the inclusion of sample expansion due to temperature changes to the sam-
ple thickness.
DXF Getting Started Guide
Page 52
Advertisement
Table of Contents
