Notes, Cautions, And Warnings; Regulatory Compliance; Safety Standards - TA Instruments DISCOVERY XENON FLASH Getting Started Manual

Notes, Cautions, and Warnings

This manual uses NOTES, CAUTIONS, and WARNINGS to emphasize important and critical
instructions. In the body of the manual these may be found in the shaded box on the outside of the page.
NOTE: A NOTE highlights important information about equipment or procedures.
CAUTION: A CAUTION emphasizes a procedure that may damage equipment or cause loss of data
if not followed correctly.
MISE EN GARDE: UNE MISE EN GARDE met l'accent sur une procédure susceptible d'endom-
mager l'équipement ou de causer la perte des données si elle n'est pas correctement suivie.
A WARNING indicates a procedure that may be hazardous to the operator or to the environment
if not followed correctly.
Un AVERTISSEMENT indique une procédure qui peut être dangereuse pour l'opérateur ou
l'environnement si elle n'est pas correctement suivie.
Please heed the warning labels and take the necessary precautions when dealing with those parts of the
instrument. The DXF Getting Started Guide contains cautions and warnings that must be
followed for your own safety.

Regulatory Compliance

Safety Standards

For Canada
CAN/CSA-C22.2 No. 61010-1 Safety requirements for electrical equipment for measurement, control, and
laboratory use, Part 1: General Requirements.
CAN/CSA-C22.2 No. 61010-2-010 Particular requirements for laboratory equipment for the heating of
materials.
For European Economic Area
(In accordance with Council Directive 2006/95/EC of 12 December 2006 on the harmonization of the laws
of Member States relating to electrical equipment designed for use within certain voltage limits.)
EN 61010-1:2012 Safety requirements for electrical equipment for measurement, control, and laboratory
use, Part 1: General Requirements + Amendments.
EN 61010-2-010:2003 Particular requirements for laboratory equipment for the heating of materials +
Amendments.
For United States
UL61010-1:2012 Electrical Equipment for Laboratory Use; Part 1: General Requirements.
DXF Getting Started Guide Page 4